Supercut 1000 Water soluble cutting fluid - 5 Litre
Supercut 1000 is a water soluble metalworking fluid of the traditional type. It is
manufactured from high quality paraffinic base oils with added preservatives along with
lubricity and anti-corrosion additives. The product is readily miscible with most mains
water to form a stable, rich, milky white emulsion of low odour and good corrosion
protection. Supercut 1000 is non-staining to both ferrous and non-ferrous alloys and may
be used in a wide variety of applications e.g. Turning (including light automatic work),
milling, drilling, boring and shaping.
Features / Benefits
• Low Odour • Economical
• Phenol / Nitrite Free • Good Corrosion Protection
Appearance (Emulsion) Rich milky white
Relative Density @ 20 °C 0.897
pH 2% in 200ppm hardness of water 9.1
Corrosion Breakpoint IP 287 4% (25:1)
*Typical values not defining a specification
Areas of Application
General Machining, free machining metals, non-critical grinding, ferrous and non-ferrous
General Machining 5% typical
Ferrous Grinding 4% typical
Higher concentrations may be employed e.g. up to 10% for more arduous applications.
Dilution: For hand mixing, always dilute to the required strength by adding the coolant concentrate to
drinking quality water, and not in the reverse order. Metering or dosing equipment can carry out this function
automatically. Freshly prepared dilutions can easily be checked for concentration using a pocket
Dilutions used for topping up frequently require to be adjusted to a lower concentration than the working
strength to accommodate for drag-out and evaporation loss. Never top up with plain water alone.
For working coolants, not too heavily contaminated with tramp oils, a reasonably accurate estimate of sump
strength can be obtained.
REFRACTOMETER READING (% brix scale) 0.8 2.2 3.6 5.0 9.0 16.0
CONCENTRATION OF COOLANT (%V/V) 1 2.5 5.0 7.5 10.0 12.5
APPROX STRENGTH COOLANT:WATER 1:100 1:40 1:20 1:15 1:10 1:8